aromozone

Products

Green Science are delighted to offer you three models of unriveled ozone production capability built to the highest known standards and constantly devloping new products and improvements without resting on our laurals.

8″ Aromozone

The AromOzone AZ108 is a single electrode cold cathode Ozone generator suitable for a 8″ ducting system.

The electrodes runs at a stable temperature of 20.1 degrees C and the transformer at 20.8 degre

The AromOzone AZ-108 is intended to fit inline in to your ducting system and although it is designed to fit a 8″ fan only, it is possible to duct up from a 4, 5 or 6″ fan to fit, however we would strongly advise any customer from ducting down on this model, rather they should buy the appropriate Aromozone solution.

The Aromozone inline solution must only be operated when the fan is switched on and requires a minimum of 10 meters of ducting before expelling outside of the environment to allow ozone to breakdown, this can be coiled round, it needs this to enable enough time for the ozone to bind.

We would advise always to run these systems on half power to establish needs then if only required, turn to full power if odors or mould is increased.

Eliminates odor, mould, bacteria, smoke as well as other pathogens.

Aromozone 10″ 2 Cell

The AromOzone AZ-210 is a twin electrode cold cathode Ozone generator suitable for a 10inch ducting system.

Our devices work at 100% humidity a situation we hope you wont face in your environment. Any moisture in an environment will be drawn down to focal points and taken away out of the environment.

The AromOzone AZ-210 ozone generator will treat all odors being exhausted by a 10″ (25cm) ventilation system.

The AromOzone AZ-210 is intended for a room size of 100,000 cu.ft. (1200 m3) and installs into other size ducting systems with adapters, The device can happily run on half power and out perform all other machines in its class including those at a larger diameter eg a 12″ variation

Aromozone 12″ 3 Cell

The AromOzone AZ213 is a triple electrode cold cathode Ozone generator suitable for a 12″ ducting system.

The electrodes runs at a stable temperature of 20.1 degrees C and the transformer at 20.8 degrees C.

Our devices work at 100% humidity a situation we hope you wont face in your environment. We are able to spray our devices directly with water and know that no degradation will occur. Any moisture in an environment will be drawn down to focal points and taken away out of the environment.

The AromOzone AZ-213 ozone generator will treat all odors being exhausted by a 12″ ventilation system. The AromOzone AZ-213 is intended to fit inline in to your ducting system and is designed to fit an 12″ fan only.

The Aromozone inline solution must only be operated when the fan is switched on and requires a minimum of 10 meters of ducting before expelling outside of the environment to allow ozone to breakdown.

We would advise always to run these systems on half power to establish needs then if only required, turn to full power if odors or mould is increased.

Eliminates odor, mould, bacteria, smoke as well as other pathogens